Filter
Top Products
22
U
SING THE RECOVER BUTTON
Use this procedure only if you have accidentally changed the TV
channel or video input. It does not recover lost satellite signal.
Note: RECOVER will first try to tune your TV to channel 3, then
channel 4, and then other video inputs with each press of the
RECOVER button. You may need to press the RECOVER button
up to 30 times to recover your satellite TV video.
1. Press and hold the RECOVER button until all four mode
buttons light, and then let go of the button. The SAT mode
button flashes twice and then all four mode buttons flash three
times.
2. Press the RECOVER button. Wait for the TV mode button to
flash once and then all four mode buttons to flash once.
3. If you see the System Info screen, press the SELECT button
to close the screen. You have recovered your satellite video.
4. If you do not see the System Info screen, repeat steps 2 and 3
until you have recovered your satellite video.
Note: Press any remote control button other than the
RECOVER button to end this procedure.
PROGRAMMING THE RECOVER BUTTON TO TUNE THE TV
TO A SPECIFIC CHANNEL
The RECOVER button can be programmed to tune your TV back
to the TV channel you use to watch satellite programming.
1. Program your remote to control your TV using the instructions
in Setting Up to Control Other Devices on page 8.
2. Press and hold the TV mode button until all the other mode
buttons light up, and then let go of the button. The TV mode
button flashes.
3. Press the STAR (*) button.
4. Enter the three digits of your channel number. For example, if
your remote TV is set to channel 60, enter 0-6-0.
5. Press the POUND (#) button. The TV mode button flashes
three times.
text_dishpvr.fm Page 22 Tuesday, March 2, 2004 12:35 PM