D-Link DGS-1210-24 TV Receiver User Manual


 
Command Line Interface D-Link Web Smart Switch User Manual
9
9
4
4
DGS-1210-24:admin#upload firmware_toTFTP 10.90.90.10 RUNTIME
Connecting to server................... Done.
Upload firmware........................ Done.
DGS-1210-24:admin#
config ipif System
Purpose This command is used to configure the System IP interface.
Syntax
config ipif System {ipaddress <ip-address> <subnet-mask>
gateway <gw-address> | dhcp | bootp}
Description
The config ipif S ystem
command configures the System IP
interface on the Switch.
Parameters
ipaddress <ip-address> <subnet-mask> Specifies the IP address
and subnet mask to be created. Users need to specify the IP
address and subnet mask information using the traditional format
(For example, 10.1.2.3/255.0.0.0).
gateway <gw-address> Specifies the IP address of the router or
gateway.
dhcp
Allows the selection of the DHCP protocol for the
assignment of an IP address to the Switch’s System IP interface.
bootp Allows the selection of the BOOTP to the Switch.
Restrictions None.
Example usage:
To configure the IP interface System:
DGS-1210-24:admin#config ipif System ipaddress 10.90.90.2 255.0.0.0 gateway
10.90.90.1
Success.
DGS-1210-24:admin#
logout
Purpose This command is used to logout a user from the Switch’s
Command Line Interface.
Syntax
logout
Description
The logout command terminates the current user’s session from
the Switch’s console.
Parameters None.
Restrictions None.
Example usage:
To terminate the current user’s console session: