Filter
Top Products
Configuration D-Link Web Smart Switch User Manual
4
4
1
1
Restricted Role: Toggle between True and False to set the restricted role state of the packet. If set to True,
the port will never be selected to be the Root port. The default value is False.
Restricted TCN: Toggle between True and False to set the restricted TCN of the packet. Topology Change
Notification (TCN) is a BPDU that a bridge sends out to its root port to signal a topology change. If set to
True, it stops the port from propagating received TCN and to other ports. The default value is False.
Click Apply for the settings to take effect. Click Refresh to renew the page.
The Trunking function enables the combining of two or more ports together to increase bandwidth. Up to
eight Trunk groups may be created, and each group consists up to eight ports.
L2 Functions > Link Aggregation > Port Trunking
Figure 4.43 – L2 Functions > Link Aggregation > Port Trunking
Link Aggregation: Click to enable or disable link aggregation.
Group: Use the drop-down menu to select a trunk group.
Type: Two types of link aggregation can be selected.
Static - Static link aggregation.
LACP - LACP (Link Aggregation Control Protocol) is enabled on the device. LACP allows for the
automatic detection of links in a Port Trunking Group.
Select the ports to be grouped together, and then click Apply to activate the selected Trunking groups.
NOTE:
Each combined trunk port must be
connected to devices within the same VLAN
group.
The LACP Port Settings is used to create port trunking groups on the Switch. The user may set which ports
will be active and passive in processing and sending LACP control frames.
L2 Functions > Link Aggregation > LACP Port Settings