Filter
Top Products
4
Installing and removing the standDX-26LD150A11/DX-32LD150A11
Installing and removing the
stand
If you plan to use your TV/DVD combo in an upright position on a flat
surface, you must install your TV/DVD combo into the stand. If you
intend to mount your TV/DVD combo on a wall or other vertical surface,
you must remove the stand and stand column.
Warning: Before attempting assembly or removal of the stand, unplug
the AC power cord.
Cautions:
Read these instructions thoroughly before attempting this installation.
Make sure that you handle your TV/DVD combo very carefully when
attempting assembly or removal of the stand. If you are not sure of
your ability to do this, or to use the tools necessary to complete this job,
refer to a professional installer or service personnel. The manufacturer
is not responsible for any damages or injuries that occur due to
mishandling or improper assembly.
When using a table or bench as an aid to assembly, make sure that you
place the TV/DVD combo on a soft cushion or covering to prevent
accidental scratching or damage to your TV/DVD combo’s finish.
Installing the stand (DX-26LD150A11)
You need to install the stand to use the TV/DVD combo in the upright
position on a flat surface.
To install the stand (DX-26LD150A11):
1 Remove the stand from the box and place it on a table or bench.
2 Secure the stand to the stand column with the four screws with
washers provided.
3 Lay your TV/DVD combo face down on a soft, dry, lint free surface
so that your TV/DVD combo is not scratched. Align the bottom
side of the TV/DVD combo with one edge of the table.
4 Slide the stand column into the slot in the bottom of the TV/DVD
combo.
5 Secure the stand with the five screws and washers provided.
6 Place your TV/DVD combo in an upright position on a flat surface.
Installing the stand (DX-32LD150A11)
You need to install the stand to use the TV/DVD combo in the upright
position on a flat surface.
To install the stand (DX-32LD150A11):
1 Remove the stand from the box and place it on a table or bench.
2 Secure the stand column to the stand with the four screws with
washers provided.
3 Lay your TV/DVD combo face down on a soft, dry, and lint free
surface. Align the bottom side of the TV/DVD combo with one
edge of the table.
Stand screws (M4*8) with
washers
Stand
Stand screws
(M4*10) with
washers
Stand
Screws (M4*10) with washers
Stand column
Stand
DX-26LD-36LD_09-1090.book Page 4 Wednesday, January 27, 2010 8:33 AM