Filter
Top Products
21
Installation
The preparation display will disappear
after 30 seconds.
(See page 52 for Lamp control status.)
Lamp control status
Turning On the Projector
Connect the projector’s AC power cord into an AC
outlet. The POWER indicator lights red. Open the Lens
cap (see pages 9,59).
Press the POWER ON/SYAND-BY button on the top
control or on the remote control. The POWER indicator
lights green and the cooling fans start to operate. The
preparation display appears on the screen and the count
down starts.
2
3
1
4
After the countdown, the input source that was selected
the last time and the lamp control status icon (see page
52) appear on the screen.
If the projector is locked with a PIN code, PIN code
input dialog box will appear. Enter the PIN code as
instructed below.
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
What is PIN code?
PIN (Personal Identification Number) code is a security
code that allows the person who knows it to operate the
projector. Setting a PIN code prevents unauthorized use of
the projector.
A PIN code consists of a four-digit number. Refer to the PIN
code lock function in the Setting Menu on pages 53-54 for
locking operation of the projector with your PIN code.
Enter a PIN code
Use the Point ▲▼ buttons to enter a number. Press the Point
► button to fix the number and move the red frame pointer
to the next box. The number changes to “.” If you fixed an
incorrect number, use the Point ◄ button to move the pointer
to the number you want to correct, and then enter the correct
number.
Repeat this step to complete entering a four-digit number.
After entering the four-digit number, move the pointer to “Set.”
Press the SELECT button so that you can start to operate the
projector.
If you entered an incorrect PIN code, “PIN code” and the
number () will turn red for a moment. Enter the correct
PIN code all over again.
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector can no
longer be started. Take a special care in setting
a new PIN code; write down the number in a
column on page 75 of this manual and keep
it at hand. Should the PIN code be missing or
forgotten, consult your dealer or service center.
Selected Input Source and Lamp Control
After the OK icon disappears,
you can operate the projector.
PIN Code Input Dialog Box
Notes:
• When the Logo select function is set to
“Off,” the logo will not be shown on the
screen (p.49).
• When the “Countdown off” or “Off” is
selected in the Display function, the
countdown will not be shown on the
screen (p.47).
• During the countdown period, all
operations are invalid.
• If the correct PIN code number is not
entered within three minutes after the
PIN code dialog box appeared, the
projector will be turned off automatically.
• The “1234” is set as the initial PIN code
at the factory.
• When the Input Search function is set to
“On2”, the input signal will be searched
automatically (p.50)
Note:
• The Filter warning and Lamp
replacement icons may appear on the
screen depending on the usage state of
the projector.
Basic Operation
16