Filter
Top Products
VN-Matrix 300 • System Conguration 30
Device Setup (c)
The Device setup area allows a VN-Matrix 300 device to be congured as either an
encoder or as a decoder.
NOTE: The VN-Matrix 300 is available as a decoder (VND 300) only. In this case it is not
possible to configure the unit as an encoder.
Create Source (Encoder)
Select this option to create a source (ENCODER).
z Source will be shown adjacent to a change device type button.
z A videoport and ancport icon will be created in the Configuration window.
Figure 17. Source (Encoder) Configuration and Setup
The
Device Setup area provides access to the following controls and information.
z Mode:
z Enable — Normal operation; image transport is enabled.
z Disable — Image transport is disabled.
z Standby — Same as disable.
z Identify — When checked, causes the name of the device to be overlaid on the content
that is presented on the SDI-OUT connector on the rear panel.
z Data Interface — The selection defines which of the two network interfaces is to be
used for the data transport.
z Multicast TTL — This value sets the Time To Live (TTL) for multicast packets.
Configuration (d)
The Configuration area provides access to the device configuration pages.
z Click on an icon to access the configuration pages.