Filter
Top Products
VN-Matrix 300 • System Conguration 32
Configuration Page — Videoport (Encoder)
The encoder Configure page provides:
z Status information for the encoder
z Access to the Bandwidth Management page
z Stream statistics and multicast configuration
Figure 19. Configuration Page
Encoder Videoport Panel
The top panel of the videoport (Encoder) Configure page (see figure 19) provides the
following information:
z Name — This may be changed to a User specic value. This is the name that is applied
to the video port, that is, the name of the image stream. Note that this need not be the
same as the name applied to the physical unit itself.
z Input Mode — The VN-Matrix 300 codec supports a fully automatic detection of the
connected signal format. No manual configuration is required.
z Current Mode — This value reports the currently detected source type.
z Source Status — This value reports the status of the input connection.
z Unplugged — Indicates that either there is no source connected or no invalid video
is present.
z Active — Indicates that a valid video connection is present.