Filter
Top Products
27
COMPUTER MODE
SELECTING COMPUTER SYSTEM
Automatic Multiscanning system
This projector automatically adapt to most different types of
computer based on VGA, SVGA or XGA (refer to
"COMPATIBLE COMPUTER SPECIFICATION" on page 28).
When selecting "Computer 1," "Computer 2," or "Computer 3",
this projector become automatically suited to the incoming
signal and projectors the proper image without any special
setting. (Setting of the Computer System may be required when
connecting some computers.)
The projector cannot discriminate or detect the input
signal from the computer. Adjust and set the
computer system manually. (Refer to PC
ADJUSTMENT on page 28.)
Note : The projector may provides the messages below.
There is no signal from the computer on the any
terminal (the Rear Terminal or the Front Terminal).
Make sure the connection of the computer and the
projector is set correctly.
(Refer to TROUBLESHOOTING on page 43.)
Go PC adj.
No signal
Selecting Computer System Manually
Press the MENU button and the ON-SCREEN MENU will appear.
Press the POINT LEFT/RIGHT buttons to select SYSTEM and
press the SELECT (REAR CLICK) button. Another dialog box
COMPUTER MODE Menu will appear. (The COMPUTER MODE
Menu also appears by pressing the SYSTEM button on the Front
Control or the Remote Control Units.)
Press the POINT DOWN button and a red-arrow icon will appear.
Move the arrow to the system that you want to set, and then press
SELECT (REAR CLICK) button.
1
2
To set the Computer system manually, select the Mode from the
COMPUTER SYSTEM Menu on the ON-SCREEN MENU.
It displays the SYSTEM
being selected.
SYSTEM BOX
The system being
selected.
The system on this
dialog box can be
selected.
When this mark is
displayed as black, more
computer system modes
will be available. Move
the arrow to this mark
and then press the
SELECT (REAR CLICK)
button, and another
mode will be displayed.
It terminates the
SYSTEM Menu.
VGA 1
VGA 1
VGA 2
VGA 3
MODE 1
MODE 2
VGA 1