Filter
Top Products
40
APPENDIX
MOUSE/KEYBOARD CONNECTION
Connecting Mouse/Keyboard to the Projector
Connect the Mouse/Keyboard Cable(s) in the Storage Cabinet (left side) to your computer as the figure below. Be sure to
connect the cable(s) corresponding with your computer.
Connect a Mouse or a Keyboard to the Mouse/Keyboard Terminal on the Front Terminal. Be sure to connect to the
terminal corresponding with the input device.
1
2
This projector equips the Mouse/Keyboard Cables in the Storage Cabinet (left side), and the Mouse/Keyboard
Terminals on the Front Terminal. Connecting these cables and terminals enable you to control the computer easily.
Connect the computer to the COMPUTER IN 1 terminal(s). Refer to page 14 and 15 for the connection.
3
KEY BOARD
MOUSE
MAC
Keyboard of IBM-Compatible
Computer
Mouse of IBM-
Compatible
Computer
Keyboard and Mouse of Macintosh
Computer
To the IBM-Keyboard
Terminal
To the IBM-Mouse
Terminal
To the Macintosh-Keyboard /
Mouse Terminal
To a Keyboard or a Mouse
terminal of IBM-Compatible
Computer
To a Keyboard terminal
of Macintosh Computer
To AUDIO 1 To COMPUTER 1
VGA Cable
(supplied)
MAC/VGA
Adapter
(supplied)
To a Monitor
Output
terminal
To a Audio
Output
terminal
Audio Cable
(not supplied)
Cable Slot
When Connecting the computer to
the Rear Terminal, cut Cable Slot(s)
and run through the cables.
IBM-Compatible Computer or
Macintosh Computer
u Refer to page 14 and 15 for
connecting the computer to
the projector.
Caution
Be sure to connect the
Mouse/Keyboard Cables
corresponding with your computer.
And be sure to connect to the
Mouse/Keyboard Terminals
corresponding with your input
devices.
To COMPUTER IN 1 terminal
4
When the steps 1, 2, and 3 are finished, switch the projector on before turning the computer on.
* Adapter is used for Macintosh
computer. Refer to the page 15.