10
To prevent accidents and to ensure safety during disasters such as earthquakes, take precautions to ensure
that the equipment cannot topple over.
ATTACHING TO WALL OR COLUMN
• Remove the display cover from both sides. Then, for both left and right sides, use screw A (10 mm) to attach
bracket A to the screw hole (highest of the five holes on the side).
• For both left and right sides, use screw B (20 mm) to attach bracket B to the wall. Then tie brackets A and B with
a strong rope so that the display panel does not topple over.
• This arrangement is stable when the rope is horizontal or pulled downward.
ATTACHING TO DESKTOP STAND
• Fasten the screws supplied with the desktop stand into their holes at the rear of the desktop stand. (2 holes)
• For details, refer to P-42TT01 User‘s Manual for the desktop stand.
Two
places
Screw B (20 mm)
The screws are supplied with the desktop stand.
PREVENTING EQUIPMENT FROM FALLING
Strong rope (not supplied)
Bracket A Bracket B
Screw A (10 mm)
Screw B (20 mm)
Display
Display cover
Push,
then pull
the cover
with the
fingers.
Display cover
How to remove display cover