Filter
Top Products
29
ENGLISH
SETTING VIDEO SYSTEM AND CLAMP PULSE
VIDEO SYSTEM
VIDEO SYSTEM can be set when the signal is connected to the VIDEO or
S-VIDEO input terminal.
Set by adjusting to the connected signal.
In VIDEO or S-VIDEO mode, press the MENU button to select SOURCE.
Select with the ADJUST button.
Pressing the ADJUST button moves the selection to the next item as be-
low.
∗ When N-PAL and M-PAL signals are input, signals cannot be received
successfully in AUTO mode. Select either N-PAL or M-PAL.
∗ This setting can be done in VIDEO mode and S-VIDEO mode only. The
VIDEO SYSTEM setting is saved for VIDEO mode and S-VIDEO mode.
CLAMP PULSE
When connecting a color difference signal to the COMPONENT VIDEO
input terminal, CLAMP PULSE must be set.
This setting switches the phase of the clamp pulse.
The ADJUST button can be adjusted in the range from 0 through 4.
Select so that optimum picture is attained.
∗ This setting can be done in COMPONENT VIDEO mode only.
CLAMP PULSE
0
MENU
RETURN
ADJUST
SET
NEXT
AUTO NTSC PAL SECAM
4.43NTSC M-PAL N-PAL
VIDEO SYSTEM
AUTO
MENU
RETURN
SELECT
Adjustment items
• Pressing the SET button moves selection to the next item.
• Set CLAMP PULSE as follows, depending on the connected device signal.
1 : MUSE signal (Hi-Vision – Japanese high definition video signal)
4: NTSC, PAL, SECAM
When connecting the other devices than the ones described above, adjust the clamp pulse so that the optimum image is
obtained.
If there is no operation for 60 seconds, the screen display goes off.