Filter
Top Products
Other Information
42 Chapter 5
Streaks appear in the picture during normal playback
• Press one of the remote control’s TRACKING buttons to adjust for the best picture.
• Make sure the tape used is in good condition and not worn out.
Tapes play back in slow motion
• Press the PLAY button to return to normal playback mode.
A tape with its safety tab removed doesn’t start to play automatically
• Make sure the Auto Play feature is set to ON in the PREFERENCES menu.
The time counter is not working or it is not working in search modes
• The time counter does not advance during unrecorded portions of tape. When an
unrecorded segment of tape is encountered, the time counter will hold its count until
recorded material is detected again.
• A minus sign (–) appears in front of the displayed time if you rewind a tape back further than
a counter reading of 0:00:00.
The VCR will not play
• Make sure there is a tape in the VCR.
• Try ejecting, then reinserting the tape.
• Check to make sure the tape is not damaged or broken.
• Make sure the VCR is not in Pause mode. Press the remote control’s PAUSE or PLAY button
to return to normal playback.
• Make sure the Pro-Tect Plus feature is not activated (press and hold the STOP button on the
remote control or VCR front panel for several seconds until the front panel display flashes to
activate/deactivate this feature).
• If unable to record, make sure the safety tab on the tape is in place.
The time counter disappears during picture search
• This is normal.
There is no stereo sound during playback
• Make sure the Tape Playback feature is set to HI-FI in the AUDIO menu to hear stereo sound
during playback.
• You must use A/V jacks and cables to connect the VCR to the TV (or stereo) to hear multi
channel stereo sound.
The stereo audio is too noisy
• The stereo signal is weak. Set the Reception: STEREO/SAP/MONO feature to MONO in the
AUDIO menu.
• Press either of the remote control’s TRACKING buttons to minimize audio noise.