Filter
Top Products
GE Energy Services
Protocol X DCA
Configuration Guide
A197-0CG-1.00-2 Restricted
2
Full
1.2 Configuration Sequence
The following is a list of the steps required to configure the ANSI X3.28 DCA:
1. Edit the ANSI X3.28 DCA configuration. Prepare it according to the guidelines in this
document and the specific use for which the ANSI X3.28 DCA is required.
2. Edit the configuration for the other applications that will run on the product. Prepare them
according to their own configuration guides.
3. Generate the configuration and download it to the product using a GE Energy Services
Configuration System. The list of applications to be compiled must include the ANSI X3.28
DCA, application A197-0.
4. Restart the product. If the ANSI X3.28 DCA encounters an error during its initialization, it
will log a message to the WESMAINT Error Log and then, depending on the severity of the
error, terminate or continue with its run-time function.
5. Check for error messages. Log into the WESMAINT maintenance interface, select the
System Functions item from the Main Menu, and then select the Error Log item from the
System Functions Menu. If any error messages are displayed, correct the problem as
described in Appendix A: Messages Logged by the ANSI X3.28 DCA, and repeat steps 3
through 5.
When the ANSI X3.28 DCA has successfully validated all the configuration parameters,
configuration is complete.