Filter
Top Products
3. Press "1" button to select "TV" or "CATV". If your
VCR is connected to a home antenna system,
select "TV", select "CATV" when your VCR is
connected to a cable antenna. Switching is
performed between "TV" and "CATV" on the TV
screen every time "1" button is pressed.
PUSH SELECTION NUMBER
1 TV SYSTEM (CATV)
2 AUTO CHANNEL SET
3 LANGUAGE SELECT
TO END PUSH MENU
4. Press "2" button for channel setting. The tuner will
automatically cycle through all available channels
in the area and place them in the tuner's memory.
After auto-presetting is completed, the lowest
active channel number stays on.
TO ADD OR ERASE CHANNELS FROM
CHANNEL MEMORY
This feature allows you to manually add or remove
channels from the channel scan. To do so, please
refer to the procedure below:
TO ERASE A CHANNEL(S)
1. Turn the TV and tune to channel 3 or 4.
2. Press the POWER ON/OFF button to turn the
VCR on. The "VCR" indicator will light on the dis-
play panel of the VCR.
3. Press "CHANNEL" select button ( • or • ) for an
unwanted channel.
4. Press the ADD/ERASE button for eliminating the
channel, and the channel display flashes on the
TV screen.
5. Repeat steps 3 and 4 until all unwanted channels
have been eliminated.
NOTE: This VCR is equipped with AFT (Automatic
Fine Tuning). But it does not have an
ON/OFF switch.
AUTO CHANNEL SET
PROCEEDING
CHANNEL:--- CATV
TO END PUSH MENU
5. Press the MENU button to return to the TV
screen.
NOTE: To check the presetting, first set the TV to
the VCR channel and press "CHANNEL" select
button (UP or DOWN) to cycle to VCR tuner
through all the channels you have stored in
memory.
TO ADD A CHANNEL(S)
.
.
.
Press channel select buttons to select the desired
channel (by using the "0" through "9" and "100"
button).
Press "ADD/ERASE" button to store the channel,
and the channel display flashing will stop.
Repeat steps 6 and 7 for other desired channels
in your area.
Now both standard TV channels and CATV
channels has been preset.
-12-