Filter
Top Products
SET YOUR TELEVISION TO THE VCR CHANNEL
1. Set your TV to Channel 3 unless Channel 3 is
one of the TV stations in your area. If Channel 3
is used in your area, set your "IV to Channel 4.
The RF Channel Select Switch is located on the
Rear Control Panel. Slide the switch of CH3 or
CH4 to match the channel selector on your IV.
This is the VCR channel on your television set.
Your television receiver must be. tuned to this
channel any time a video cassette is played back
on the VCR.
e.® Iooooooooo
"RF Channel" Select Swltch
2. Plug the VCR power cord into a 120V electrical
outlet and press "POWER" ON/OFF button on,
and the "POWER" and "VCR" lights will come on.
(See "Clock Setting" Instructions on page 21.)
NOTE: When the power is turned on, the
"VCR/TV" selector is switched to the VCR mode
automatically.
"POWER" ON/OFF Button
3. Select an active TV channel by pressing the
Channel Select button ( • or •) on the remote
control aiming at the front panel of the VCR. The
picture from that channel should now be dis-
played on your television.
NOTES:
• If the range is short, try new batteries.
cAn object between the VCR and remote control
may block the invisible light beam and operation
will not be possible.
"CHANNEL"
Select Button (• or •)
0 .......o6
TR_3KING
G®®
®®®
®®®
4. Fine tune the television for best picture.
NOTE: If both Channel 3 and Channel 4 are in
use in your area, select the one which does not
interfere with the playback picture.
SPECIAL NOTE:
Certain television receivers with "ELECTRONIC
TUNERS" may require special procedures to tune
Channel 3 or 4. These receivers may not tune to the
VCR channel (3 or 4) because there isn't an active
"IV station on these channels.
In these cases, press VCR "POWER" ON/OFF
button on. Make sure that the "VCR" indicator in the
display panel is on. If the indicator is off, press
"VCR/I-V" selector on the remote control to turn the
"VCR" indicator on. Tune VCR tuner to an active
channel. The television receiver will now tune into
the VCR channel (Channel 3 or 4). For more
detailed instructions, consult your TV owners
manual.
HOW TO INSTALL THE BATTERIES IN THE
REMOTE CONTROL
_ OTES:
1. Be sure to install two
"AAA" size batteries (not
supplied) before use.
2. Be aware of the polarity
(Remove the protect compartment cover comple-
tely.)
-13-