Filter
Top Products
USING EXTERNAL DEVICES
38
Adapting the digital output to a digital multi-channel
amplifier
With this you choose whether the decoder signal is processed in the unit or fed
unchanged to the digital output. With internal decoding, there is a stereo signal
(PCM) at the digital output.
1 Press » « to call up the main menu.
2 Select »Sound« and press »OK«.
3 Select »Extended Settings« and press »OK«.
4 Select »Digital« and press »OK«.
Note:
For further operation, see the following sections, each one starting from
Step 1.
Selecting audio signal types for the digital output
The audio signal type must be selected according to the connected decoder/amplifier.
1 Select »Output format« and press »OK«.
2 Select the required output format, (»DOLBY« »MPEG«, or »PCM«) with »"«
or »!« and confirm with »OK«.
3 Select the audio signal type (»Original« or »PCM«) with »"« or »!« and
then press »OK« to confirm.
4 Return to the »Digital« menu by pressing » «.
Setting the bit rate
Here you choose the possible digital resolution and the dynamic range possible
of the output signal in order to adapt the signal to the decoder.
1 Select »Bits« and press »OK«.
2 Select the desired value (»16«, »20«, or »24«) with »"« or »!« and press
»OK« to confirm.
Setting the sampling rate
This function is used to limit the sampling rate of the digital multi-channel
amplifier.
1 Select »Clock rate« and press »OK«.
– This has been set to »48 kHz« at the factory.
DISC MODE
Digital
Sound
Analogue
●
Back
●
Quit
DOLBY
Output format
MPEG
PCM
●
Back
●
Quit
Original
16
Bits
20
24
●
Back
●
Quit
Original
Original