Filter
Top Products
Connecting the television and VCR …
… using aerial (RF) cables
1 Connect the cable of your TV aerial to the »Aerial In« socket on the Receiver/Player.
2 Connect the short aerial from the »Loop Through« socket to the »RF IN« socket, both
on the Receiver/Player.
3 Connect the long aerial lead from the »RF Out 1« socket to your TV or VCR »Aerial
IN«
… using SCART cables
1 Plug the standard SCART cable (supplied) into the »TV« scart socket on the
Receiver/Player and the appropriate socket for RGB reproduction on the TV set. See TV
user guide for details on this.
2 Plug a standard SCART cable (not supplied) into the »VCR« scart socket on the
Receiver/Player and the TV socket on the VCR.
3 If required connect the other devices as shown in the diagram above.
4 If you wish to connect the Receiver/Player to your HiFi system for improved sound, plug
standard phono cables into the »AUDIO OUT L R« sockets and into the appropriate
sockets on your HiFi system.
… using a Y/C cable (S-Video) and phono cables
1 Plug a standard Y/C cable into the »S-VIDEO« socket on the Receiver/Player and into
the appropriate socket (S-VIDEO IN) on the television.
2 Plug standard phono AV cables into the »AUDIO OUT L R« sockets on the
Receiver/Player and the appropriate sockets (AUDIO IN) on the television.
Note:
As this product is a combination product, this manual will deal with the two halves of the
product separately. To switch between the two modes (TV mode and Disc mode) press
the » « key.
If the Receiver/Player is connected via the »S-VIDEO« socket, before you can use Disc
mode, you must carry out the setting described in “Selecting the video output socket” in the
Disc section of this book.
9
CONNECTION AND PREPARATION
TV
Aerial