Filter
Top Products
8 108933
INSTALL AN ATTENUATOR
Stray UHF signals can block signals from the remote control
to the receiver. To prevent blocks, you can install a 10 dB attenuator
(you can buy one from a consumer electronics parts store).
Note: This will help keep out stray UHF signals, but also cut down
how far away you can use the remote control.
1.Take the UHF antenna off
of the receiver’sback panel
UHF Remote Antenna input.
2.Put a 10 dB attenuator onto the
UHF Remote Antenna input.
3.Put the UHF antenna onto the
attenuator.
SWITCH BETWEEN TV AND DEVICE VOLUME CONTROL
If you set up the remote to control a television, the Mute and Volume
buttonscontrolthe TV volume, in most modes. But,if youuse the Aux
mode to control a tuner or amplifier and the device has a volume
setting, you can set up the remote to control the device’s volume
instead