Grundig Platinum PVR Remote Control Universal Remote User Manual


 
Attach the Remote Control Antenna
108933 7
4.Use the number buttons to enter any number
from 1 to 16, but not the one you found in step 2.
The Sat mode button goes out after you enter
each digit, and then lights up again.
Write down the number you enter _______.
5.Press the Pound (#) button.
If the address you enter works, the Sat mode button
flashes three times.
6.Press the Record button.
7.This is important: Make sure the Remote Address
on the Important System Information menu now
is the same as the one you entered in step 4. If it isn’t,
the remote can’t control the receiver.
8.To check the address, press and hold the Sat mode
button for three seconds. Then, let go of the Sat button,
and press the Pound (#) button twice.TheSat mode
button flashes the same number of times as the address
youenteredinstep4.
9.Press the Select button to close the
Important System Information menu.
ATTACH THE REMOTE CONTROL ANTENNA
To use the remote’s UHF signals to
control the receiver, you must attach the
UHF antenna to the receiver’s back
panel UHF Remote Antenna input.
Set the antenna straight up so you can
use the remote as far away as possible.
Note: If you don’t attach the antenna, you can still use the remote
to control the receiver at short distances. This is because
theremotesendsboth IR and UHF signals to the receiver.
text_dishpvr.fm Page 7 Thursday, July12,2001 10:02 AM