Grundig Platinum PVR Remote Control Universal Remote User Manual


 
6 108933
C
HECK THE DEVICE CODES
You can find out what device code you’ve set for each remote control
mode. Here’s whatto do:
1.Press and hold the mode button for the device, for about three
seconds. When all the other mode buttons light up, let go of the
mode button.
2.Press the Pound (#)buttontwice.
The mode button flashes the number for each digit of the device
code, with a pause between the groups of flashes. A quick flash
is for zero. For example, the mode button flashes five times,
pauses, flashes seven times, pauses, and flashes once quickly
for the 570 code.
CHANGE THE ADDRESS
Because UHF signals travel long distances and go through walls,
a neighbor’s remote may control your receiver by mistake.
To handle this problem, you can change the remote address.
Note: Here we show you examples of the receiver’s front panel
buttons. Your receiver’s buttons may look a bit different.
1.Open the Important System Information menu.
To do this, first make sure you turn the TV on.
Next, press the receiver’s front panel Power button
to turn the receiver off. Then, press the receiver’s
frontpanelInfo button. (Please don’tuse theremote
control’s buttons because they might control your
neighbor’s receiver.)
2.The Important System Information menu
shows a Remote Address.
Write down this number: _______.
3.Press and hold the Sat mode button about three
seconds, until all the mode buttons light up,
andthenletgooftheSat button.
(pleasegoontothenextpage)
text_dishpvr.fm Page 6 Thursday, July12,2001 10:02 AM