HP (Hewlett-Packard) LC3260N Flat Panel Television User Manual


 
Troubleshooting
Troubleshooting 45
Troubleshooting
Refer to this section if you have viewing, picture, sound,
remote, or startup problems with your TV.
Startup questions
Symptom Remedy
I do not hear sound at power-on even
though there is an image.
Is the volume too low? Press the Volume Up button.
Is mute turned on? Press the Mute button, or the Vol+ button.
Is an external sound system connected and turned on? Are the
speakers turned off in the OSD Audio menu?
I do not see an image at power-on.
Are the connections to the input signal source component correct?
Double-check that the cables are properly inserted in the color-coded
connectors.
Is the input source powered on? Turn on the set-top box, DVD player,
or other component you are trying to view.
Is the correct input signal source selected? Press the source button on
the remote control to display the source list. Use the up and down
arrow buttons to highlight a source and press OK.
Press the Menu button on the remote control.
If the OSD appears, check the cables to the input source and
press the source button on the remote control to choose the input
source.
If the OSD does not display, see the next symptom, “There is no
power.”
There is no power.
Press the Power button on the remote control unit.
If the indicator on the TV is red, press the Power button on the TV.
Is the AC cord disconnected? Make sure both ends of the power
cord are plugged in.
Is there power coming from the outlet? Plug in a functional lamp or
other electrical device into the same outlet as the TV to make sure
there is power coming from the outlet.
If using a power strip, make sure it is turned on.
sa6ldtv.book Page 45 Tuesday, February 21, 2006 12:35 PM