Filter
Top Products
Turning On the TV
Turning On the TV 17
Turning On the TV
Turning the TV On and Off (Standby)
The TV has a Power button (A) on the front of the
display. You can also use the remote control Power
button to turn on the TV.
Pressing the Power button either turns the TV on or
places it into standby, which is a reduced power state.
A Power button and light
B Remote control sensor
The Power button includes an indicator light, which
shows the power status of the TV.
After the initial setup, the power-up time from standby
depends on the Standby Mode setting:
■ Low power, which consumes less power while in
standby, uses approximately 20 seconds of
power-up time.
■ Fast power, which consumes more power while in
standby, uses approximately 5 seconds of power-
up time.
You can set the Standby Mode by using the
System menu.
If the TV is not used for an extended period of time,
press the Power button to place the TV into standby,
and then unplug the power cord.
Using the TV buttons
1 Press the Power button (A) on the front of the TV.
The TV is on or in standby.
2 Press SRC button to open the list of input sources.
Press CH+ to select the input source to view, and
press OK. Press SRC to close the list.
Power indicator Power status
Lights red Standby (off)
Lights blue Ready (on)
Off AC power
disconnected
Flashing red or
flashing blue
Start up diagnostics or
error
MENU
OK
+
VOL
–
+
CH
–
SRC
A
B
n
The initial setup starts when the TV powers
on for the first time. If the TV has been
turned on before, the Setup Wizard does
not start. See “Starting the Setup Wizard”
on page 40 to start the Setup Wizard from
the System menu.