Filter
Top Products
RECORDING
42
• To prevent tape damage, after five minutes, the TV/VCR will automatically
return to the Recording mode.
• When in the Pause/Still mode, a display showing 5 "" marks will appear on the
screen. Each "" mark represents one minute of Pause time. You may refer to
this display for remaining pause time available.
• If "CAPTION1", "CAPTION2", "TEXT1" or "TEXT2" is selected, the On Screen
Display will appear for 5 seconds, then disappear.
If you want to check the remaining pause time available using the On Screen
Display, press SELECT button. The On Screen Display will appear for 5
seconds.
OTR (One Touch Recording)
This function enables you to set a recording length simply by pressing the
REC/OTR button on the TV/VCR.
Make sure...
• Power must be turned on.
• Insert a cassette tape with its erase prevention tab in place. (If necessary,
rewind or fast forward the tape to the point at which you want to begin
recording.)
NOTE: This function cannot be done by the remote control.
1 Select the channel to be recorded
Press number buttons on the remote control or the CH or button.
2 Begin OTR
Press REC/OTR button on the TV/VCR as many times as needed. The
recording length will be determined by the number of times you press
REC/OTR button.
Each additional push will increase the recording time by 30 minutes. It is set
up to 8 hours.
HINTS:
• Recording starts immediately when the REC/OTR button is pressed.
• When REC/OTR button is pressed 18 times, the TV/VCR will switch to the
Normal Recording mode.
• To stop the OTR operation, press STOP button on the TV/VCR or on the
remote control.
• To show the remaining time, press SELECT button repeatedly until "OTR"
appears on the TV screen.