TIMER
48
Press POWER button to set automatic timer recording.
The REC indicator lights up.
• You must turn off the TV/VCR to activate automatic timer recording.
If power is not turned off and you continue watching TV, "TIMER REC
STANDBY" starts flashing on the TV screen 2 minutes before the
programmed start time.
TO CORRECT A PROGRAM
• While setting a program; press ADD/DELETE button to go back one step,
and enter correct numbers using CH or button.
• After setting a program;
1) Press POWER button.
2) Repeat steps [1] - [2].
3) Press SELECT button repeatedly (or press ADD/DELETE button to go
back one step) until a digit you want to correct flashes, then make changes
4) Repeat steps [10] and [11].
TO CANCEL AN AUTOMATIC TIMER RECORDING
• While setting or after setting a program;
1) Press POWER button.
2) Repeat steps [1] ~ [2] and select a program number you want to cancel.
3) Press ADD/DELETE button.
4) Press MENU button to return to the TV mode.
• While recording is in progress;
1) Press POWER button.
2) Press STOP/EJECT button on the TV/VCR.
If you press POWER button to turn off before the end time, timer recording
will continued. Repeat steps [1] ~ [2], select a program number you want to
cancel and press ADD/DELETE button. Press MENU button to return to the
TV mode.
VCR PLUS+ (SETTING USER CHANNELS)
You will notice that some stations have guide and local channel numbers that
are the same, and other stations have channel numbers that do not match. In
case where the channel number DO NOT match, it is necessary for you to
memorize user channels to guide channels according to the steps below.
NOTE: You must use the remote control for this procedure.
Make sure...
• Power must be turned on to set user channels.
• Preset the tuner.
1 Select "CHANNEL SET UP"
Press MENU button repeatedly to point to "CHANNEL SET UP".
Press SELECT button.
2 Select "GUIDE CH"