Filter
Top Products
HOW TO USE THE REMOTE TO CONTROL YOUR TV - 18 -
Press this button to display the SLEEP TIMER in the lower left corner of the screen. Every subsequent
press of this button will add 15 minutes to the timer, up to a maximum of three hours.
3 MENU, CURSOR Buttons
All On-Screen Display features can be set or adjusted by using these buttons.
The MENU button will start the On-Screen Display.
The CURSOR buttons will highlight functions or adjust and set different features when MENU is pressed.
The CURSOR button will move PIP position when PIP is on.
CURSOR buttons will also give you access to FAMILY FAVORITE On-Screen Display.
4 CHANNEL SELECTOR Buttons
Enter two or three numbers to select channels. Enter "0" first for channels 1 to 9. For channels 100 and
above, press the "1" button and wait for two seconds before pressing the last two digits of the channel.
Channel selection may also be performed by pressing CH up (
) or down ( ).
You may also use these buttons for channel scanning. Press and hold the CH up (
) or down ( )
buttons and the TV will start quickly scanning through the channels. Release the CH up (
) or down
(
) buttons when the TV scans to the channel you wish to watch and the TV will tune to that channel.
NOTE: The TV may not receive some channels if you are not in the correct SIGNAL SOURCE mode.
(See page 39.)
5 INPUT Button
The INPUT button will select between both (only antenna A signal for the 36CX35B model) antenna
signals and the four sets of video input jacks each time the button is pressed. Except for the 36CX35B
model: If the Picture-in-Picture is on, the INPUT button will select between the four sets of video input
jacks and both antenna sources when main channel is chosen with the PIP CH button (CLU-431UI remote
only). If the sub-picture is chosen, the INPUT button will select between the four sets of video input jacks
and the ANT A source (ANT B source cannot be displayed as a PIP Sub-Picture.)
For 36CX35B model: If the Picture-in-Picture (PinP) is on, the INPUT will not select any source signal on
the main picture. However, the INPUT will alternate between the main signal source and the input source
on the sub-picture.
6 VOLUME, MUTE Buttons