Filter
Top Products
FRONT PANEL CONTROLS
10
ቧ POWER button
Display Monitor “MAIN POWER” button
This power button is for the complete system, and must be turned ON/OFF manually. It is recommended to leave the “MAIN
POWER” to ON condition (lights red) for stand-by mode.
AVC POWER button
The AVC power can be turned ON/OFF manually or by remote control. Turning on the AVC Power will only turn on the AVC box if
the “MAIN POWER” of the display monitor is off.
ቨ POWER light indicator
To turn the monitor ON, press the main power switch located on the lower right side of the monitor. A red stand-by indicator lamp
located on the lower right corner of the front bezel will illuminate. The LCD TV is now ready for remote on/off operation.
ቩ REMOTE CONTROL sensor
Point your remote at this area when selecting channels, adjusting volume, etc.
ቪ FRONT INPUT JACKS (for VIDEO: 5)
Use these audio/video jacks for a quick hook-up from a camcorder or VCR to instantly view your favorite show or new recording.
Press the INPUTS button then use the CURSOR PAD and the SELECT button on the remote control to select INPUT 5. If you have
mono sound, insert the audio cable into the left audio jack.
ቫ PHONES JACK
Use this jack for your head-phones. The TV’s internal speakers can also be heard. Turn off the internal speakers (see page 61) if
you wish to listen to the head-phones only.
ቭ LEARNING AV NET Sensor
NOTES: 1. Your HITACHI LCD TV will appear to be turned OFF (lights orange) if there is no video input when VIDEO: 1, 2, 3,
4, 5, or RGB is selected. Check the Power Light to make sure the Display Monitor is turned off or in Stand-by
mode (lights red) when not in use.
2. Remote Control can not turn ON/OFF the “MAIN POWER” of the display monitor.
Indicating Lamp Power Status Operating
Off Off When the main power switch is set
OFF.
Lights Red Off When the main power switch on the display
(Stand-by) monitor is ON, and the AVC Center is OFF.
Lights Green On Display monitor MAIN POWER is ON and
AVC Center power is ON.
Lights Orange Off Display monitor MAIN POWER is ON and
Flicking Green
(only in the AVC)
The AVC is
preparing to
turn ON
When the MAIN POWER switch on the
(Power Saving) and
display monitor is ON or OFF and the AVC
center power is turning on.
AVC Center power is ON, with no signal
input except antenna (no sync. signal).
STANDBY (RED) ON (GREEN)
MAIN POWER
Back side view
The Main Power button is located on the Back side, under the label “MAIN POWER”.
FIRST TIME USE