Filter
Top Products
35
G
U
I
D
E
A
/
V
N
E
T
HOW TO USE THE REMOTE
TO CONTROL YOUR LCD TV
AV NET LEARNING WIZARD
For example, after programming your AV Receiver to the AV NET and the soft keys do not work, the user has to use the AV NET
Learning Wizard. The AV NET Learning Wizard will transfer any remote button IR code of your AV Receiver to the soft keys of
your AV NET. Since an AVR2 (Custom) is not available in the device setup screen, the user can choose any custom device. For
this setup example, we have chosen the PVR2 (Custom) device.
5. Use the CURSOR PAD to select the prefered Softkeys (Ex. ̄
button) to learn, press the SELECT button.
1. Press A/V NET button on the remote control.
2. Use the CURSOR PAD ̄ and ̆ to select DEVICE SETUP,
press the SELECT button or CURSOR PAD ̈.
3. Use the CURSOR PAD/SELECT button to choose CUSTOM
option (Ex. PVR2).
4. Use the CURSOR PAD to select Setup, press the SELECT
button.
NOTES:
1. To access the Menu function of a specific equipment, select
the “MENU” soft key on OSD, then press the MENU button of
the LCD Television remote control. In order to use CURSOR
PAD and EXIT button of the LCD Television remote control,
“arrows, select, and EXIT” button must be learned. Then the
menu of the programmed equipment can be controlled with
the LCD Television remote control.
2. When using the Learned device with the Timer Recording
function, the Power, Stop and Record soft Keys should be
learned first.
6. Press and hold the ̄ button of the AVR remote control while
pointing directly at the learning AV NET sensor of the LCD
Television (located behind the screen) at a distance of 2
to 3 meters or 5 to 10 feet.
8. If the code transfer was succesful, the screen below appears.
9. Select OK to continue.
10. A check mark appears next to the programmed softkey.
Select DONE to EXIT or CONTINUE to learn another softkey.
7. If the code is not accepted, the screen below appears.
HITACHI AV NET WIZARD (Learning)
Transfer not completed!
Try again?
NO YES
Move
SEL
Select
11. Use the CURSOR PAD ̄ to select Video Input. Press the
CURSOR PADS ̇,̈ to set the INPUT to which your
device is connected.
12. Repeat step 11 for Audio Input. If the AVR is connected to
the TV, select “Using TV”. If the AVR is connected to an
external amplifier, select “no connection”.
13. Press CURSOR PAD ̄ to select Transmission Test. Perform
a Transmission Test by selecting Power, Play, or CH UP
softkeys. If the device responds, then it is properly set up.
Select OK.
14.Press Done.
15. Press Exit to Quit.
THE REMOTE CONTROL