Hitachi 37LD9700C Flat Panel Television User Manual


 
51
ENGLISH
FUNCTION
Power Swivel
With the Desktop stand, you can adjust the angle of the panel side to side by pressing
SWIVEL
button on the remote
control.
1. Press
SWIVEL
button on the remote control.
The Swivel Display (as shown in the gure on the right) will appear on the
screen.
2. Adjust the angle of the panel with button while Swivel Display is on the
screen.
The unit will be able to rotate ±30 degrees to each side.
NOTE
If the stand cable is not connected to the unit, the message “Not Available”
will appear on the screen.
The Swivel Display will automatically disappear when no operation has
been made for about 6 seconds.
The Swivel Display
Swivel
CAUTION
Do not push the panel with your hands while operating the Swivel. It could damage the panel and/or stand.
Do not allow children to play or hang on the TV. These actions may tip it over, causing personal injury.
Do not swing the unit back and forth.
Do not place any fragile objects around the unit. The unit would hit the object(s) during the Swivel operation and
could cause the breakage of the objects and/or the stand.
To operate the Swivel function correctly, place the unit on the stable surface.
When you use the unit as wall-mounting, disconnect the stand cable from the unit before installation.
SWIVEL
button
Information
About Swivel terminal connection
CAUTION
Turn Off the Main Power of the unit when connecting or disconnecting the stand cable to the unit.
To disconnect the stand from
the unit.
Before detach the stand from
the unit, make sure to
disconnect the stand cable
from the Swivel terminal on
the rear side of the unit.
POWER SWIVEL
CAUTION
When you use the Power Swivel function, make sure that the Power Cord, cord
or chain connected to the wall is loose enough to operate the Swivel function
securely.
Do not put hands or face near the unit while operating the Swivel. It could cause
personal injury. Beware especially when small children are around the unit.
To connect the Desktop stand
to the unit.
Connect the designated stand
cable to the Swivel terminal
on the rear side of the unit.
POWER SWIVEL
30°
30°
Slack