Filter
Top Products
22
(3) VCR button
When the VCR button is pressed, it will blink to indicate the remote is in VCR mode. (See page 28)
(4) CABLE (CBL)
When the CABLE button is pressed, it will blink to indicate the remote is in CABLE mode. (See page 29)
(5) SATELLITE (SAT)
When the SAT button is pressed, it will blink, to indicate the remote is in SATELLITE mode. (See page
30)
(6) DVD button
When the DVD button is pressed, it will blink, to indicate the remote is in DVD mode. (See page 31)
(7) AV1, AV2, AV3 buttons
When pressed, each of these buttons will blink to indicate the remote is in Audio/Video mode. (See page
32)
(8) CHANNEL selector buttons
CHANNEL selector buttons are used to set FAMILY FAVORITES, CHANNEL MEMORY, etc.
Enter one, two or three numbers to select channels. Enter "0" first for channels 1 to 9, or simply press the
single digit channel you wish to tune then wait a few seconds for the TV to tune. For channels 100 and
above, press the "1" button, wait until two dashes appears next to the channel display on your TV, then
enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up (
) or down ( ).
You can also use these number buttons to directly access OSD sub-menu's of your choice. While navigating
the On-Screen-Display's, you will notice that each sub-menu has a number next to it. For example the SET
UP menu has 9 sub-menu's. Pressing the (7) button while in the SET UP menu will take you directly to the
CLOCK SET sub-menu. This makes navigating the menu's faster and easier.
NOTE: The TV may not receive some channels if you are not in the correct SIGNAL SOURCE mode.
(See page 38)
(9) SLEEP button
Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of
this button will add 15 minutes to this timer, up to a maximum of three hours. Once set, use RECALL when
you want to view time remaining. If the SLEEP button is pressed while the timer is set, it will reset to the
original condition.
(10) LAST CHANNEL (LAST CH) button
Use this button to select between the last two channels viewed. (Good for watching two sporting events,
etc.)
(11) INPUT button
The INPUT button will select between antenna signal and the three sets of video input jacks each time the
button is pressed. If the Picture-in-Picture is on, the INPUT button will select between the three sets of
video input jacks and both antenna sources when main channel is chosen with the PIP CH button. If the
sub-picture is chosen, the INPUT button will select between the three sets of video input jacks and the ANT
A source (ANT B source cannot be displayed as a PIP sub-picture).
(12) C.C. button
Press this button to quickly turn the Closed Caption feature on and off (see page 56 for more information).
(13) HELP button
Press this button when a menu is displayed to view HELP text, which gives a description of the displayed
menu. The HELP text will be displayed every time a MENU is displayed, until this button is pressed again.