Filter
Top Products
30
USING THE REMOTE TO CONTROL DVD FUNCTIONS
Operating the precoded function for your DVD player.
This remote is designed to operate different types of DVD players. You must first program the remote to
match the remote system of your DVD player. (refer to page 33 for precodes)
1. Turn ON your DVD player.
2. Aim the remote control at the front of your DVD player.
3. Press and release the DVD button to switch to DVD pre-coded mode.
4. Hold down the DVD button on the remote and enter the two digit preset code that matches your DVD
player, as shown on page 33. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD
player when the correct two digit preset code is entered. When this occurs, the remote control is
programmed for your DVD player. If the DVD player does not turn off, try a different two digit preset
code.
6. The remote will now control your DVD player.
NOTES:
1. If your DVD player cannot be operated after performing the above procedures, your DVD player code
has not been precoded into the remote.
2. In the unlikely event that your DVD player cannot be operated after performing the above procedures,
please consult your DVD player operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed
from the remote control. After replacing the batteries repeat the entire programming procedure stated
above.
(1) DVD Button
This button allows the remote to control your DVD player by setting it to DVD mode.
(2) PRECODED DVD Buttons
These buttons transmit the chosen precoded DVD codes.
(3) EXCLUSIVE TV Buttons
These buttons are for operating the TV.
MY DVD PLAYER CODE IS:___________________
NOTE: Refer to instruction manual of the DVD player for operation of the buttons exclusively for the
DVD player.