Filter
Top Products
49
OTHER FUNCTIONS
ASPECT MODE
ǏWhen non HD component signal is received:ǐ
You may set different aspect modes to view the image with different signal formats.
You can change between four different modes including lj4:3NJ, lj4:3 ZoomNJandlj16:9NJ, lj16:9 ZoomNJ.
Please do not watch TV at non full screen size, this may cause damage to your PRT.
Please see the following on each of four modes for details.
ƽTo switch aspect mode, please press the P.SIZE button when the word showing the corresponding aspect
mode will appear momentarily at the lower part of the screen. For example, set the current aspect mode to
lj4:3NJ as shown at the lower left side. If lj4:3 ZoomNJ is set as shown at the lower right side, you can press
the ŸP+ źP- cursor buttons to adjust the display position up and down before the words Ālj4 : 3Zoom +3NJ
Scroll” disappears as shown at the lower right side.
ǏWhen HD component signal is received:ǐ
Press the P.SIZE button to switch between two different modes including lj16:9NJandlj16:9ZoomNJ.
Notes˖
1ˊ The aspect mode will return to the mode of lj16:9NJ(when HD signal is received ) or lj4:3NJ(w
hen
conventional signal is received) after completing the program selection and restarting the TV.
2ˊ In multi picture, pressing the P.SIZE button has no effect.
3ˊ Using this special function (aspect mode) to change the size of image displayed for purpose of public
release or some commercial interests (i.e., change the ratio of height and width), this may infringe the
law of copyright.
Signal sources
ljNJ
lj=RRPNJ
ljNJ
Suggested
aspect
mode
lj=RRPNJ
ljNJ
lj˖=RRPNJ6FUROO
For example:
Conventional TV
b
roadcast forma
t
For example:
signal transformed
from HD
For example:
16:9 widescreen cinema