Hitachi VT-M290A VCR User Manual


 
ANTENNA/CABLE SYSTEM CONNECTIONS
17
CATV COAXIAL CABLE
(1) Disconnect the CATV coaxial cable from the back of your TV set.
(2) Reconnect the CATV coaxial cable to ANT.IN terminal of the VCR.
(3) Connect one end of the COAXIAL CABLE (supplied) to the ANT.OUT jack of the
VCR.
(4) Connect the other end of the COAXIAL CABLE (supplied) to the antenna/cable jack
of your TV.
See CATV Connection Diagram.
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40 of
the NEC that provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building as close to the
point of cable entry as practical.
SEPARATE VHF (75-OHM) / UHF (300-OHM) ANTENNA
(1) Disconnect the VHF coaxial antenna cable and the UHF flat twin-lead antenna cable
from the back of your TV set.
(2) Reconnect those cables to a UHF/VHF combiner (not supplied).
(3) Connect end of the UHF/VHF combiner to the ANT.IN terminal of the VCR.
(4) Connect one end of the COAXIAL CABLE (supplied) to the ANT.OUT terminal of the
VCR.
(5) Connect the other end of the COAXIAL CABLE (supplied) to a UHF/VHF separator
(not supplied).