Filter
Top Products
CHANNEL MEMORY PROGRAMMING (Without a Cable Box) pg. 16.
21
To Set your TV to the Video Mode
Connection Using Av cord (Refer to page 14.): Set your TV to the Video Mode using
VCR/TV button of your TV. To set your TV to the TV mode, press VCR/TV button of
your TV again.
Connection Without AV Cord (Refer to page 12, 13, 15): Set the TV channel to the
same video output channel located on the back of the VCR. (CH 3 or 4) Then, set your
VCR to the VCR mode using VCR/TV button of your VCR.
CHANNEL MEMORY PROGRAMMING (Without a Cable Box) pg. 16.
Channel memory programming is NOT needed when connected to a CABLE BOX. You
can program the tuner to scan only the channels you receive in your area. See page 33
for channel designations.
You must use remote control for this procedure.
NOTES:
Follow the steps below, once. Repeat it only if there is a power failure or the VCR is
unplugged for more than 30 seconds. In these cases, since the programmed channels are
erased, the VCR will prompt you with "--:--" when you turn it on.
You must follow the steps below before attempting to play or record a video tape. If you
want to play ore record a video tap BEFORE programming the tuner, you must first press
POWER button to turn off the VCR. Then, press POWER button again to turn it back on.
To program the tuner again, see "To preset channel memory again" on this page.
1
Plug the VCR power cord into a standard AC outlet. The "--:--" flashes.
2