Humax IHDR-5200C DVR User Manual


 
10
Quick Start Guide
Connecting the Network
ݎConnecting to the LAN;
Connect one end of the Ethernet cable to the product and the other end to the LAN router.
ݏConnecting to the Wi-Fi (Wireless LAN); (Reserved for future use.)
You can connect the network via the Wi-Fi access point or DSL/cable modem.
1. Plug in the wireless USB dongle to the USB port. (Separate purchase required)
2. Set the options for the Wi-Fi.
Network Name (SSID): Select the network name of your Wi-Fi access point from the list.
Security Type (WEP): This product supports WEP 40/128bit ASCII and WEP 40/128bit HEX. The security type of
the Wi-Fi and the product shall be set the same.
Password: When using the security type, you must set the password. Enter the same password in the Wi-Fi
setting menu.
3. After completing the Wi-Fi access point setting, make sure the settings in Installation Wizard or
Settings>System>Network>Congure Wi-Fi are the same.
Note:
Make sure the distance between the Wi-Fi access point and the product is not too far away. This may
lower the quality of service.
It is recommended to purchase a wireless USB dongle distributed by HUMAX. Other products may not
function or respond. Visit the HUMAX website to nd the information on purchasing a wireless USB
dongle. (http://www.myhumax.nl)
Note:
We recommend the network connection over a direct LAN.
LAN
RouterWireless Router
Ethernet Cable
1
2
WLAN USB Dongle