Filter
Top Products
English
Menu On/O Select Conrm Enter 0~9
53
Installation
Software Update (OTA)
In order to maintain proper performance of the product, it is essential to have the most up-to-date
software. Visit the HUMAX website to check the latest news and newly released software versions. (http://
www.myhumax.nl) It is recommended that you periodically check for the availability of software update.
OTA, an abbreviation of Over–the-Air, means that the software can be downloaded through your
broadcast system. The manufacturer reserves the right to decide when and where to release software by
this process.
You can also search and download new software manually.
MENU Settings Installation IRDETO Software Update
You can update software via the frequency pre-appointed by the manufacturer.
1. Select IRDETO Software Update and press
the OK button to search for new software.
2. When new software is detected, select
Ye s to
start the update process now.
Please wait until the update is complete. When
completing the software update, the product is
automatically powered o and on again.
Note:
• It may take 5~10 minutes to update software.
• Other functions such as scheduling
programmes will not activate while software
update takes place.
• Be sure to update software when the signal strength and quality is high. If the weather is not favorable
and the signal strength and quality are not recommendable, perform the software update later.
• The product will search new software automatically during standby. If new software is detected, you
can choose either to download immediately or later when you switch into operation mode. If you
select No, the message will be displayed again when you power on.
• You can also update the software by connecting a USB device which has the new software le. The le
can be downloaded from the HUMAX website.
Caution:
• Please be careful to keep the power on and the power cord plugged in during software update. If the
power is o during software update, fatal damage may be caused to the product.
• Please be careful not to pull out the signal line (RF cable) during software update. Update may be
interrupted and the product may not operate.