Filter
Top Products
PRJ-WALLKIT-11 Installation Instructions
6 Visit the InFocus support site at www.infocus.com/support
ASSEMBLY AND INSTALLATION
The single stud short throw wall mount can be mounted to
concrete, concrete block, 2" x 4" wood studs or steel studs.
Installing Mounting Bracket
WARNING: ELECTRICAL SHOCK HAZARD! CUTTING
OR DRILLING INTO ELECTRICAL CORDS OR CABLES
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is free
of electrical wires and cables before cutting, drilling, or
installing fasteners.
WARNING: EXPLOSION AND FIRE HAZARD! CUTTING
OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH
OR SERIOUS PERSONAL INJURY! ALWAYS make certain
area behind mounting surface is free of gas, water, waste, or
any other plumbing before cutting, drilling, or installing
fasteners.
Mounting Wall Bracket
Concrete or Concrete Block
1. Determine mounting location on wall.
2. Using wall bracket (B) as a template, mark four holes at the
outer holes in bracket. (See Figure 1)
3. Drill four 3/8" x 3-3/8" deep holes at marked locations in wall.
(See Figure 1)
Figure 1
4. Install four concrete anchors (Y) into drilled holes. (See
Figure 2)
5. Install four 5/16 x 2-1/2" hex head lag screws (P) through
four 5/16" washers (Q), outer holes of wall bracket (B) and
into concrete anchors (Y). (See Figure 2)
Figure 2
Wood Studs
1. Determine mounting location on wall. Use a stud finder to
locate studs.
2. Line up inner three holes on wall bracket (B) with center of
stud at desired mounting location. (See Figure 3)
3. Using wall bracket (B) as a template, mark three holes at
inner three holes in bracket. (See Figure 3)
4. Drill three 7/32" x 2-1/2" deep holes at locations marked in
Step 3. (See Figure 3)
Figure 3
2
3
x 4
(front view)
(B)
(P) x 4
5
(Y) x 4
4
(B)
(Q) x 4
(front view)
(B)
wood stud
3
4
x 3