Filter
Top Products
23
Insignia 32" LCD TV/Blu-ray Combo, 1080p
www.insigniaproducts.com
If you selected Antenna or Cable, your
TV/Blu-ray combo automatically scans for
available channels in your area and stores the
channel information in the channel list. This may
take several minutes. While scanning, your
TV/Blu-ray combo display a progress bar.
If you selected Cable/Satellite Box, your
TV/Blu-ray combo does not need to scan for
channels, and no progress bar is displayed.
8 If you connected a cable or satellite TV box,
press INPUT to open the source list, press
INPUT repeatedly or press or to highlight
the jack the box is connected to, then press
ENTER.
Understanding TV basics
Turning your TV/Blu-ray combo on or off
To turn your TV/Blu-ray combo on or off:
1 Make sure that you have connected the power
cord to your TV/Blu-ray combo and a power
outlet.
2 Press (power). Your TV/Blu-ray combo turns
on and the power indicator on the front of your
TV/Blu-ray combo turns blue.
3 Press (power) again. Your TV/Blu-ray combo
turns off (Standby mode) and the power
indicator on the front of your TV/Blu-ray combo
turns red.
Selecting the video input source
To select the video input source:
1 Press INPUT. The input source list opens.
2 Press INPUT repeatedly or press or to
highlight a video input source, then press
ENTER. You can select:
• TV
•BLU-RAY
• AV (device connected to the AV INPUT VIDEO
or AV INPUT S-VIDEO jack)
• Component-1
• Component-2
•HDMI-1
•HDMI-2
•HDMI-3
•VGA
Notes
• During auto scan, digital channels will be
scanned first, then analog channels. When all
available digital channels have been found, the
message will ask you “Do you want to continue
scanning analog channel?” You can select No,
then press ENTER to exit the analog channel
scan, or let your TV/Blu-ray combo continue
scanning.
•You can press MENU or EXIT at any time to stop
the auto scan, but you will need to run the auto
scan again to create a channel list.
Note
Unless otherwise noted, all tasks in this section are
based on using the remote control.
Warning
When your TV/Blu-ray combo is in Standby mode,
power still flows into it. To disconnect power, unplug
the power cord.
Note
When your TV/Blu-ray combo does not receive a
signal and you do not press any buttons for 15
minutes, your TV/Blu-ray combo goes into Standby
mode.