JVC 0610TMH-MW-ST Flat Panel Television User Manual


 
59
English
Reference
Refer to the table below to check the condition. If you think that there is a problem, contact the
JVC Service Center where you purchased the television.
There is no power
Check that the power cord is plugged in properly.
Check for a blown fuse or circuit breaker, or a power outage.
There is no picture or sound
The antenna could be disconnected.
The tuner could be set improperly. See page 53.
The TV station may be having difficulties. Check to see if other stations are working.
Use an HDMI cable with the HDMI logo.
If you have a device connected to INPUT-1, INPUT-2 or INPUT-3, you will not be able to
hear any audio from the AUDIO OUT on the back of the TV.
You cannot output audio using the DIGITAL AUDIO OPTICAL OUT when you have digital
sound from an HDMI device connected to the INPUT-1, INPUT-2 or INPUT-3 connection
on the back of the TV.
This TV can accept 480i (Composite / S / HDMI / Component), 480p, 720p, 1080i and
1080p signals. Please check your settings.
Remote control is not operating properly or at all
Check to see that the batteries are still working and properly installed.
Make sure the remote has a clear sight path to the TV.
You may be too far from the TV. You must be within 23 feet (7 meters).
The power turns off by itself
Check that the power cord is plugged in properly.
• Perhaps the Auto Shut Off is set. See page 43.
Check to see if the Sleep Timer was set. See page 19.
It does not operate correctly
This television is operated by a microprocessor. It is possible that external noise or
interference is causing the problem. If the television does not function correctly, remove
the electrical plug from the wall outlet and wait a while before inserting it into the wall
outlet again and operating the television.
The color quality is poor
Tint and Color may be improperly adjusted. See page 26.
• The Video Status mode may be set incorrectly. See page 26.
There are lines across the picture
There could be interference from another electrical appliance, such as a computer,
another TV or a VCR. Move any such appliances further away from the TV.
The picture is spotted
There could be interference from a high-wattage appliance, like a hairdryer or vacuum,
operating nearby. Move the antenna away from the appliance or change to a coaxial
cable connection which is less prone to interference.
There are double pictures (ghosts)
A building or passing airplane may reflect the original signal and produce a second,
slightly delayed one. Adjust your antenna position.
Troubleshooting
EN_LT32P510.indb 59EN_LT32P510.indb 59 10.6.1 6:01:51 PM10.6.1 6:01:51 PM