JVC AV32P10EK, AV32L5EK, AV32P10EI, AV32L5EI CRT Television User Manual


 
42
AV32L5/P10EKEI / LCT0909-001A-U / English
Troubleshooting
TroubleshootingTroubleshooting
Troubleshooting
If a problem arises while you are using the TV, please read this troubleshooting guide carefully before you ask to have the TV
repaired. You may be able to fix it easily by yourself. For example, if the mains plug is disconnected from the mains outlet, or the
TV aerial has problems, you may think there is a problem with the TV itself.
Important:
This troubleshooting guide only covers problems whose causes are not easy to decide. If you have a question when you are
operating a function, read the page(s) for that function carefully, not this troubleshooting guide.
If you follow the advice in this troubleshooting guide without any success, unplug the mains plug and ask for your TV to be
repaired. Do not attempt to repair the TV by yourself or to remove the rear cover of the TV.
If you cannot turn on the TV
If you cannot turn on the TVIf you cannot turn on the TV
If you cannot turn on the TV
Is the mains plug connected to the mains outlet?
Is the power lamp lit? If not, press the main power button.
No picture or no sound
No picture or no soundNo picture or no sound
No picture or no sound
Have you chosen a TV channel with very poor reception? If
so, the BLUE BACK function will be activated: the entire
screen becomes blue, and the sound is muted. If you still
want to view the TV channel, follow the description BLUE
BACK on page 28 to try to change the BLUE BACK function
setting to OFF.
Have you set the speaker function to OFF? Follow the
description SPEAKER on page 21 to check the speaker
function setting.
Poor picture
Poor picturePoor picture
Poor picture
If noise (snow) totally blocks out the picture, there may be a
problem with the aerial or aerial cable. Check the following
to try to solve the problem:
Have the TV and aerial been connected properly?
Has the aerial cable been damaged?
Is the aerial pointing in the right direction?
Is the aerial itself faulty?
If the TV or aerial suffers interference from other equipment,
stripes or noise may appear in the picture. Move any
equipment such as an amplifier, personal computer, or a
hair drier, that can cause interference away from your TV.
Or try moving the TV. If the aerial suffers interference from
a radio tower or high-voltage wire, please contact your local
dealer.
If the TV suffers interference from signals reflecting from
mountains or buildings, double-pictures (ghosting) will
occur. Try to change the aerials direction or replace it with
one with better directionality.
Are your COLOUR SYSTEM settings correct? Follow the
description COLOUR SYSTEM on page 20 to try a way to
solve the trouble.
Have the COLOUR and BRIGHT settings been adjusted
properly? Follow the description Picture adjustment on
page 18 to try to adjust them properly.
Videotaping teletext is not recommended because it may
not record correctly.
When a white and bright still image (such as a white dress)
is displayed on the screen, the white part may look as if it is
coloured. This is unavoidable due to the nature of the picture
tube itself, and not due to a TV failure. When the picture
disappears from the screen, the unnatural colours will also
disappear.
When viewing images from commercially available video
software products, or videos from videotapes which have
been recorded improperly, the top of the image may be
distorted. This is due to the condition of the video signal, and
not because of malfunction.
Poor sound
Poor soundPoor sound
Poor sound
Have you adjusted BASS or TREBLE properly? If not, follow
the description Sound adjustment on page 21.
When TV channel reception is poor, it can be hard to hear
the stereo or bilingual sound. In this case, follow the
description STEREO / III on page 21 to hear the sound
more easily by changing it to a mono sound.
If the TV does not respond to the
If the TV does not respond to the If the TV does not respond to the
If the TV does not respond to the
remote control.
remote control.remote control.
remote control.
Have the batteries of the remote control worn out? Follow
the description Putting batteries into the remote control on
page 4 and replace them with new batteries.
Have you attempted to use the remote control from the sides
or rear of the TV or from more than seven metres away from
the TV? Use the remote control in the front of your TV or
from less than seven metres away.
When you want to change the volume of the headphones,
follow the description HEADPHONE on page 22.
When you are viewing a teletext programme, you cannot
operate the menus. Press the
b
button to return to the
ordinary TV programme, and then try operating the menus.
If the TV will not respond suddenly, press the main power
button on the TV and turn off the main power. Press the
main power button again to turn on the TV. If the TV returns
to a normal state, it is not a failure.
Other issues
Other issuesOther issues
Other issues
When the SLEEP TIMER function operates, the TV is
automatically turned off. If the TV is turned off suddenly, try
to press the
#
(standby) button to turn on the TV once
again. If the TV goes back to normal, there is no problem.
When a wide screen signal (WSS) is included in the broadcast
signal or the signal from an external device, or when the TV is
receiving a control signal from an external device, the ZOOM
mode will change automatically. When you want to return to
the previous ZOOM mode, press the
c
button to choose the ZOOM mode again.
If you bring a magnetised device such as a speaker near to
your TV, the picture may be warped or unnatural colors may
appear at the corners of the screen. In this case, keep the
device from your TV. If speakers cause this to happen, use
magnetic-shielded speakers instead.
A picture may be tilted due to the earths own magnetic field.
If so, use the PICTURE TILT on page 20 to correct the tilt.
It takes a short time from the time an operation such as
changing channels is performed until an image is displayed.
This is not a malfunction. This is the time it takes for the
image to stabilize before it can be displayed.
The TV may make a crackling sound due to a sudden
change in temperature. The picture or sound may be
normal. If you hear crackling sounds frequently while you
are viewing the TV, there may be other causes. As a
precaution, ask your service technician to inspect it.
Touching the screen may cause you to feel a slight electric
shock due to its static electricity. This is unavoidable due to the
construction of the picture tube. It is not a problem with the TV.
You can rest assured that this static discharge is not harmful.
English.book Page 42 Monday, June 18, 2001 4:57 PM