Filter
Top Products
EN 31
SET TAPE SPEED
4
D-VHS mode:
Press STD/LS3 ( ) to set the tape speed.
S-VHS or VHS mode:
Press SP/LP ( ) to set the tape speed.
SET VPS/PDC MODE
5
Press VPS/PDC to select "ON" or "OFF".
If "VPS/PDC ON" is displayed on the screen or "VPS/
PDC" is lit on the display panel, VPS/PDC is set to ON.
If "VPS/PDC OFF" is displayed on the screen or "VPS/PDC"
is not lit on the display panel, VPS/PDC is set to OFF.
੬ "VPS/PDC Recording" on page 33.
RETURN TO NORMAL SCREEN
6
Press PROG or OK. "PROGRAM COMPLETED" appears
on the screen for about 5 seconds, then normal screen
appears.
● Repeat steps 1 – 6 for each additional programme.
ENGAGE RECORDER’S TIMER MODE
7
Press ‰ (or ‰TIMER). The recorder turns off automati-
cally and ‰ appears on the display panel. The ‰TIMER
indicator on the recorder also lights up.
● To disengage the timer, press ‰ (or ‰TIMER) again.
NOTES:
●
To Change The Stop Time . . .
. . . press STOP +/– in step 3. You can compensate for
anticipated programme schedule delays this way.
●
To Timer-Record Weekly Or Daily Serials . . .
. . . in step 3, press WEEKLY (NUMBER key "9") for weekly
serials or DAILY (NUMBER key "8") for daily serials (Monday
– Friday). Either "WEEKLY" or "DAILY" appears on the screen.
Pressing the button again makes the corresponding indication
disappear.
●
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen and "FULL" appears
on the front display panel. To record the extra programme, you
must first cancel any unnecessary programmes (
੬
pg. 34).
●
It is not possible to timer-record a TV programme with a
S
HOW
V
IEW
number which starts with "0".
ATTENTION
Regarding Guide Program Number Set
"GUIDE PROG SET" appears after performing step 3 if the
Guide Program number for the SHOWVIEW number you
entered has not been set.
● Press the NUMBER keys or %fi to input the channel
position number on which your recorder receives that
station, then press OK or
#
to set the Guide Program
number. The SHOWVIEW program screen appears.
(Ex.) To timer-record a ZDF
programme with the
SHOWVIEW system.
* If your recorder receives
ZDF on the channel
position 2, press OK or
#
after entering "2".
Satellite Tuner Users
To timer-record a satellite broadcast using the SHOWVIEW
system:
1 Set "AV2 SELECT" to "AV2" or "SAT" (੬ pg. 54).
2 Perform steps 1 – 7.
3 Set the satellite tuner to the appropriate channel before
the selected programme begins.
4 Leave the satellite tuner's power on.
GUIDE PROG SET
GUIDE PROG TV PROG
2 – –
[
5
∞
] =
[PROG] : EXIT
1 2 3
4 5 6
7 8 9
1
2
1
2
3
– –:– –
0
3
4
4
OK
DAILY
WEEKLY
VPS/PDC
PROG
STOP+/–
STD/LS3 (SP/LP)
‰TIMER indicator
TIMER