Filter
Top Products
74 EN
TROUBLESHOOTING (cont.)
Error Code
Some error codes may appear on the TV screen when operating the recorder. Refer to the chart below for the solution.
102
103
104
105
200
201
205
300
ERROR CODE SYMPTOM SOLUTION
● When a signal in which only the analog
information is copy protected has been input for
the dubbing in D-VHS mode.
● When a signal which is digitally copy protected
has been input for dubbing in D-VHS mode.
● When a signal which cannot be digitally converted
by the recorder has been recorded.
● When making an S-VHS/VHS recording of a signal
from DV IN connector (i.Link).
● When a signal which cannot be digitally converted
by the recorder has been input and played back.
● When normal playback is impossible such as with
a mosaic (block-shaped noise).
● When an attempt is made to play back a D-VHS
recorded tape that has been found to be invalid.
● When a signal which cannot be digitally converted
by the recorder has been input.
It is not possible to record a digitally copy protected
signal.
It is not possible to record a digitally copy protected
signal.
Sometimes a programme can be recorded but not
played back because the signal system is not
supported by the recorder. Switch to analog input
such as "L-1" to record.
The recorder’s DV IN connector (i.Link) is especially
for D-VHS recording. The digital signal is not
converted to analog and then recorded. Switch to
analog input such as "L-1" to record.
Playback is impossible because a signal system not
supported by the recorder has been input.
The recorder is making adjustments in order to
display normal picture. Please wait.
This tape cannot be played back by this recorder.
Nothing can be seen or heard because the signal
system is not supported by the recorder.