Filter
Top Products
64 EN
SUBSIDIARY SETTINGS (cont.)
ATTENTION
Guide Program numbers are not set when channels are
stored manually. If an attempt is made at timer program-
ming with SHOWVIEW in this state, the "GUIDE PROG SET"
screen appears; set the Guide Program numbers on this
screen. ੬ "ATTENTION – Regarding Guide Program
Number Set" on pg. 31.
Or perform "Guide Program Number Set" (੬ pg. 69).
Storing Channels Manually
Store channels that were not stored during Auto Set Up (੬ pg.
6), Preset Download (੬ pg. 8) or Auto Channel Set (੬ pg. 62).
SELECT BAND
4
Press
%
fi
to change the
band between CH (regular)
and CC (cable), then
press
#
.
INPUT CHANNEL
5
Press the NUMBER keys to input the channel number you
want to store.
● Input "0" before any single number entries.
● To input the registered station name (ID – ੬ pg. 67),
press
#
until "----" (ID setting) begins blinking, then
press
%
fi
.
● For fine tuning adjustment, press
#
until "+/–" begins
blinking, then press
%
fi
. While tuning, "+" or "–"
appears.
● When storing a channel that sends scrambled
broadcasts, press
#
until "OFF" (Decoder setting)
blinks, then press %fi to set "DECODER" to "ON"
("OFF" is the default setting).
● When "AV2 SELECT" is set to "AV2" or "SAT", the
"DECODER" setting cannot be changed (੬ pg. 54).
ENTER NEW CHANNEL
INFORMATION
6
Press OK and the Confirmation screen appears.
● Repeat steps 3 through 6 as necessary.
CLOSE CONFIRMATION
SCREEN
7
Press MENU.
● To change positions, see "Change Station Channel
Position" (੬ pg. 65).
● If you wish to set station names other than the ones
registered in your recorder, ੬ "Set Stations (B)" on
page 66.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
ACCESS MAIN MENU
1
Press MENU.
ACCESS CONFIRMATION
SCREEN
2
Press
%fi
to move the highlight bar (pointer) to
"MANUAL CH SET", then press OK or
#
. The Confirma-
tion screen appears.
SELECT POSITION
3
Press
%
fi
@ #
until an
open position in which
you want to store a
channel begins blinking,
then press OK. The
Manual Channel Set
screen appears.
(Ex.) To store in position 12.
∞
∞
PR CH ID PR CH ID
01 25 ARD 08 C26 E-SP
02 CDB SKY1 09 55 WEST
03 10 ZDF 10 C24 SAT1
04 C65 RAI1 11 C23 OSF
05 C31 BBC1 12
– – – –
06 C32 BBC2 13
– – – –
07 C33 3SAT 14
– – – –
[
5
∞
]
=
: EDIT
= [X] : DELETE
[MENU] : EXIT
PR CH ID FINE DECODER
12 CH01
– – – –
+/– OFF
[
5
∞
] : SELECT
[
] : CURSOR +=
: OK
[MENU] : EXIT
∞
∞
1 2 3
4 5 6
7 8 9
1
2
1
2
3
– –:– –
0
3
4
4
NUMBER
OK
MENU