Filter
Top Products
Masterpage:Right-No-Heading
EN
33
Filename [XVS20AG_07S-VHS.fm]
Page 33 April 24, 2003 3:50 pm
D
Access the G-
CODE
Program screen.
● If the number you entered is invalid, “ERROR” appears on the
TV screen. Press & and input a valid G-
CODE
number.
● If the “G-CODE/SHOWVIEW SETUP” screen appears, see
“ATTENTION” on page 33.
E
Set the tape speed.
Press
SP/LP/EP
(
p
).
● Select the appropriate colour system with “PAL/MESECAM”
and “NTSC”. (
੬
pg. 77, 78)
F
Return to the normal screen.
Press
PROG
or
OK
. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears. If “PROGRAM OVERLAPPED” appears
on the TV screen, see page 38.
● Repeat steps
B
–
F
for each additional programme.
G
Engage the unit’s timer mode.
Press
#
(
TIMER
). The unit turns off automatically and
“
#
” appears on the front display panel.
● To disengage the timer mode, press # (
TIMER
) again.
NOTES:
● To Change The Stop Time:
— press
STOP +/–
after pressing
OK
in step
D
. You can
compensate for anticipated programme schedule delays.
● To Timer-Record Weekly Or Daily Serials:
— after pressing
OK
in step
D
, press
WEEKLY
(
number key
“9”
) for weekly serials or
DAILY
(
number key “8”
) for daily
serials (Monday — Friday). Either “WEEKLY” or “DAILY”
appears on the TV screen. Pressing the button again makes the
corresponding indication disappear.
● You can programme this unit to timer-record as many as 8
programmes. If you try to programme the unit to record a
ninth, “PROGRAM FULL” appears on the TV screen. To record
the extra programme, you must first cancel any unnecessary
programmes. (
੬
pg. 37)
Press
OK
, then the G-
CODE
Program screen appears (if
you’re just starting out, “P1”
appears).
IMPORTANT
Make sure the channel position number you wish to record is
displayed; if not, see “G-
CODE
™/S
HOW
V
IEW
™ System Setup”
on page 31 and set the Guide Program number correctly.
: [OK]
– P1 –
NO. 12345678
START STOP
21:00 22:00
SP
DATE TV PROG
25.04 1
Satellite Receiver Users
To timer-record a satellite broadcast using the G-
CODE
/
S
HOW
V
IEW
system:
A Perform steps
A
–
G
.
B Set the satellite receiver to the appropriate channel before
the selected programme begins.
C Leave the satellite receiver’s power on.
ATTENTION
Guide Program Number Set
“G-CODE/SHOWVIEW SETUP” appears after performing
step
D
if the Guide Program number for the G-
CODE
number
you entered has not been set.
Press rt or the
number keys
to input the channel position
number on which your unit receives that station, then press
OK
or e to set the Guide Program number. The G-
CODE
Program screen appears.
(Example)
To timer-record a RTR
programme with the G-
CODE
system.
* If your unit receives RTR on the
channel position 2, press OK or
e
after entering “2”.
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
2 – –
[0–9] OR [ / ] : SELECT
[PROG] : EXIT
XVS20AG_07S-VHS.fm Page 33 Thursday, April 24, 2003 3:50 PM