Filter
Top Products
Filename [XVS20AG_10Subsidiary.fm]
Masterpage:Left+
84
EN
Page 84 April 9, 2003 10:50 am
SUBSIDIARY SETTINGS (cont.)
NOTES:
●
Fine tuning is performed automatically during Auto Channel
Set. If you want to perform tuning manually, refer to page 86.
●
If you perform Auto Channel Set when the aerial cable is not
connected properly, “SCAN COMPLETED –NO SIGNAL–”
appears on the TV screen in step
G
. When this happens, make
sure of the aerial connection and press OK; Auto Channel Set
will take place again.
●
If no sound accompanies the picture or the audio sounds
unnatural on some channels that have been stored by Auto Set
Up, the TV system setting for those channels may be incorrect.
Select the appropriate TV system for those channels.
(
੬
pg. 86, “TV System Selection — When you see the picture
but the audio can’t be heard or sounds unnatural”)
E
Select the TV system.
F
Perform Auto Channel Set.
G
View the channel list screen.
After “SCAN COMPLETED” is
displayed on the TV screen for
about 5 seconds, the channel
list screen looking like the one
to the right appears. The
stations your unit located
appear on a channel list screen
— channel position (CH),
frequency (“FRQ”) and TV system (SYS). The blueback
screen and the programme currently being broadcast by
the blinking station appear alternately for 8 seconds each.
To view the next page, use the rt button on the remote
control.
H
Return to the normal screen.
Press SET UP MENU.
●
Using the Confirmation screen, you can delete channels, swap
channel positions and fine-tune channels already stored. Refer
to page 85 – 86 for the procedures.
IMPORTANT
●
When programming the timer using the G-
CODE
/
S
HOW
V
IEW
system, be sure to check the desired channel is
selected correctly. (
੬
pg. 32, “G-
CODE
™/S
HOW
V
IEW
™
Timer Programming”) (S-VHS deck only)
●
Your unit memorizes all detected stations even if reception
of some of them is poor. You can delete those stations with
an unacceptable picture. (
੬
pg. 86, “Delete A Channel”)
Press rt to move the
highlight bar (pointer) to the
appropriate TV system (refer
to the table below).
Major Countries/Areas TV System
Australia, New Zealand, Kuwait, U.A.E.,
Indonesia, Singapore, Thailand, Malaysia,
Iran, Saudi Arabia, Egypt, Morocco,
Lebanon, Iraq
B/G
China, Mongolia, Russia D/K
Hong Kong I
Press OK or e.
●
The Auto Set screen appears,
and remains on screen while
the unit searches for receivable
stations. As Auto Channel Set
progresses, the “
q
” mark on the
TV screen moves from left to
right. Wait until the TV screen
as shown in step
G
appears.
[ / ]
[MENU] : EXIT
TV SYSTEM SELECT
B/G
D/K
I
AUTO CH SET
PLEASE WAIT
START FINISH
■
■
■
■
■
■
■
■
■
■
■
■
– – – – – – –
[ / ] [ ]: DELETE
[ / ] : EDIT
[MENU] : EXIT
CH FRQ SYS CH FRQ SYS
01 150 BG 07 229 BG
02 165 BG 08 237 BG
03 195 BG 09 355 BG
04 205 BG 10 365 BG
05 213 BG 11 374 BG
06 221 BG 12 384 BG
XVS20AG_01.book Page 84 Wednesday, April 9, 2003 10:53 AM