JVC HR-XVS20AA DVD VCR Combo User Manual


 
Filename [XVS20AG_11Trouble.fm]
Masterpage:Left
90
EN
Page 90 April 9, 2003 10:50 am
TROUBLESHOOTING
Before requesting service for a problem, use this chart and see if you can repair the trouble yourself. Small problems are
often easily corrected, and this can save you the trouble of sending your unit off for repair.
POWER
TAPE TRANSPORT (S-VHS deck)
PLAYBACK (S-VHS deck)
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. No power is supplied to the unit.
The mains power cord is disconnected. Connect the mains power cord.
2. The remote control wont function.
The batteries are discharged. Replace the dead batteries with new ones.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. During recording, the tape does not
run.
lights up and the channel
display blinks on the front display
panel.
The unit is in the Record Pause mode. Press
4
to resume recording.
2. The tape will not rewind or fast-
forward.
The tape is already fully rewound or
fast-forwarded.
Check the cassette.
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. The S-VHS deck can not be operated.
The S-VHS deck is not selected. On the unit
Press S-VHS/DVD repeatedly so that the
S-VHS indicator lights up.
On the remote control
Press S-VHS so that the S-VHS indicator
lights up.
2. The playback picture does not appear
while the tape is running.
If you are using the RF connection,
the TV receivers channel selector is
not set to the video channel.
the units video channel has not been
correctly set.
If you are using the RF connection,
set the TV receiver to the video
channel.
perform Video Channel Set
(
pg. 15).
If you are using the AV or S-VIDEO
connection, the TV receiver is not set to
the AV mode.
If you are using the AV or S-VIDEO
connection, set the TV to its AV mode.
3. Noise appears during visual search.
This is normal.
4. Noise appears during normal
playback.
The automatic tracking mode is
engaged.
Try manual tracking. (
pg. 26)
5. The playback picture is blurred or
interrupted while TV broadcasts are
clear or USE CLEANING CASSETTE
message appears on the screen.
The video heads may be dirty. Use a dry cleaning cassette ECL-3F, or
consult your JVC dealer.
6. Breaks are noticeable in Hi-Fi
soundtrack.
The automatic tracking mode is
engaged.
Try manual tracking. (
pg. 26)
7. Playback picture has a loss of colour.
The wrong colour system is selected for
the tape being played back.
Select the correct colour system.
(
pg. 77, 78)
The wrong colour system was selected
during recording.
Once recorded, the signal cannot be
corrected. Be sure to choose the correct
setting before recording.
8. No sound accompanies the playback
picture.
The TV system you have selected at the
TV System Select screen is incorrect.
Set it to the correct position for the TV
broadcast system used in your area.
(
pg. 86)
XVS20AG_01.book Page 90 Wednesday, April 9, 2003 10:53 AM