JVC HM-DH5U VCR User Manual


 
40 EN
TIMER RECORDING
VCR Plus+ C
3
®
Timer
Programming
Timer recording allows you to program the VCR to
automatically record a broadcast at some future time.
Up to 24 timer recording programs can be made using VCR
Plus+ timer programming or Express timer programming
method (
A
page 44) as far as a year in advance.
The VCR Plus+ timer programming system eliminates the
need to input channel, date, start and stop time data when
programming timer recording settings. Simply key in the
PlusCode number for the TV broadcast you wish to record
and the VCR’s timer will be automatically programmed.
(The PlusCode programming numbers are the numbers
next to the program in most TV listing.)
A Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
The VCR turns on, and the counter is reset,
automatically.
B Access VCR Plus+ screen
C Enter PlusCode number
Then;
If the Guide Channel Set screen appears
— go to step D.
If the VCR Plus+ Program screen appears
— go to step
E.
To make corrections, press [CANCEL] and input
the correct PlusCode number.
If an incorrect PlusCode number or one where
the broadcast already ended has been inputted,
“PLUSCODE NO. ERROR CONFIRM
PLUSCODE NO. THEN RETRY” is displayed for
about 5 seconds, then the VCR Plus+ screen
reappears.
Turn on the VCR and the TV, and select the AV
mode on the TV.
Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
A
[TIMER(j)]
[POWER]
[POWER]
BH
F
G
E
C
CD
[TIMER ( )]
[WEEKLY]
[BACK]
[DAILY]
VCR
TV
CABLE
/DBS
Press [PROGRAM] on
the Remote.
The clock must be
set to access the
VCR Plus+ screen.
If you have not set
the clock, the Main
Menu screen
appears after an
error message is
displayed. Refer to
page 17 for the
clock setting
procedure.
Press the appropriate
‘Number’ keys to
input the PlusCode
number printed in the
TV listings for the TV
broadcast you wish to
record, then press
[OK].
TIMER PROGRAM
PRESS [+/ ] TO SET EXPRESS PROGRAMMING
PRESS NUMBER KEYS [0-9] OR
STARTSTOPDATE CHEXIT
PROG.
PLUSCODE NUMBER SET
SET
TIMER PROGRAM
PRESS [+/ ] TO SET EXPRESS PROGRAMMING
PRESS NUMBER KEYS [0-9] OR
STARTSTOPDATE CHEXIT
PROG.
PLUSCODE NUMBER SET
SET
1 2 3 4 5