JVC HM-DH5U VCR User Manual


 
44 EN
TIMER RECORDING (cont.)
Express Timer
Programming
You can directly program the VCR’s timer to record up to
24 broadcasts, as far as a year in advance. Remember,
the clock must be set before you can program the timer
(A page 17).
A Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
The VCR turns on, and the counter is reset,
automatically.
B Access VCR PLUS+ screen
Press [PROGRAM].
C Access Program screen
Press [START +/–] once.
D Set program start time
E Set program stop time
Press [STOP +/–] repeatedly to enter the time you
want recording to stop.
Press and hold [STOP +/–] to increase or
decrease the time in 30-minute intervals.
F Set program date
Press [DATE +/–]. (The current date is displayed
on the screen. The date you enter appears in its
place.)
G Set channel number
Press [TV/VCR CH +/–].
If you are using a DBS receiver, see
‘ATTENTION FOR DBS RECEIVER USERS’ on
next page.
Holding down [TV/VCR CH +/–] rapidly
changes the channel numbers.
Turn on the VCR and the TV, and select the AV
mode on the TV.
Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
A
[TIMER(j)]
[POWER]
[POWER]
BJ
H
I
C - G
[TIMER ( )]
[WEEKLY]
[DAILY]
[DBS]
VCR
TV
CABLE
/DBS
Press [START +/–]
repeatedly to enter
the time you want
recording to start.
Press and hold
[START +/–] to
increase or
decrease the time in
30-minute intervals.
CONFIRM CANCEL
STD (SP)
8:00 PM
START TIME STOP TIME DATE
DAILY/WEEKLY
CH
SOURCE
TIMER PROGRAM
REC SPEED
SET PROGRAM WITH [+/ , REC SPEED
8=DAILY, 9=WEEKLY] THEN PRESS "CONFIRM"
STARTSTOPDATE CHEXIT
PROG.
EVERY SUN
AM: