Filter
Top Products
50 EN
TIMER RECORDING (cont.)
END of TIMER RECORDING
ATTENTION:
• If there is a conflict in the timer schedule and one
program overlaps with another, only the parts
shown below in gray will be recorded.
Pattern 1 : The program with the lower program
number will be recorded.
Pattern 2 : The program starting earlier will be
recorded.
Pattern 3 : The program starting earlier will be
recorded, followed by the remaining
portion of the other program.
•When using i.LINK Timer Programming or Video
Remote Control Timer Programming, if the program
stop time of the Integrated HDTV (or Digital Set Top
Box) coincides with the program start time of the
VCR or vice versa, only the parts shown below in
gray will be recorded.
NOTES:
• During timer programming, try to set an interval of more
than 1 minute between the program stop time of Program 1
and the program start time of Program 2 or vice versa.
• For the timer programming method, refer to the manual of
the Integrated HDTV (or Digital Set Top Box).
10:00
11:00
CH10
12:00
CH40
Not
recorded
Program 1
Program 2
10:00
11:00
12:00
CH40
Not recorded
Program 1
Program 2
10:00
11:00
12:00
CH10
CH40
Not recorded
Program 1
Program 2
10:00
11:00
10:00
11:00
Not recorded
Program 1
Program 2
Not recorded
Program 1
Program 2
Integrated HDTV
This VCR
Integrated HDTV
This VCR
Other Useful functions for timer recording
You can also use the following functions for timer
recording.
•“AUTO TIMER” (A page 66)
When “AUTO TIMER” is set to “ON”, the timer
recording standby mode is automatically engaged
when the VCR is turned off. It is temporarily
canceled when the VCR is turned on. You do not
have to press [TIMER (j)] to engage or disengage the
timer recording standby mode.
•“AUTO SP N EP TIMER” (S-VHS/VHS only)
(A page 66)
If there is not enough tape to record the entire
broadcast for recording in SP mode, the VCR
automatically switches to EP mode to allow
complete recording. This feature is especially handy
when recording a broadcast of more than 2 hours in
length.