Filter
Top Products
10
EN
INITIAL SETTINGS (cont.)
Clock Setting
Perform clock setting only if the clock has not been set
correctly by the Plug & Play setting or if you use a cable
box.
Access the Clock Set screen to perform the Semiauto or
Manual Clock Set. Each procedure starts from step 4
after preparation steps below are finished.
If you use a cable box, set the clock manually. (੬ pg. 12)
Preparations
1
Access Main Menu screen
Press MENU.
2
Access Initial Set screen
On the front panel:
Press CH5∞ to move
the highlight bar (arrow)
to “INITIAL SET”, then
press OK.
On the Remote:
Press %fi to move the
highlight bar (arrow) to “INITIAL SET”, then press
OK or
#
.
3
Access Clock Set screen
On the front panel:
Press CH5∞ to move
the highlight bar (arrow)
to “CLOCK SET”, then
press OK.
On the Remote:
Press %fi to move the
highlight bar (arrow) to “CLOCK SET”, then press
OK or
#
.
● “CABLE BOX USERS SET CLOCK MANUALLY”
appears on the screen for about 5 seconds, then
the Clock Set screen appears.
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
MAIN MENU
FUNCTION SET
TUNER SET
=
INITIAL SET
REC LEVEL CTL
VIDEO NAVIGATION
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END
INITIAL SET
=
CLOCK SET
LANGUAGE ENGLISH
GUIDE CHANNEL SET
CABLE BOX SET
DBS RECEIVER SET
JLIP ID NO. SET
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
1 8
2 – 7
2 – 7
123
456
7
89
0
VCR TV CABLE/DBS
1 8
2 – 7
2 3
2 – 7
HR-S9800U-EN01-22 00.3.29, 7:25 PM10