Filter
Top Products
EN
63
JLIP ID Number
Setting
The JLIP (Joint Level Interface Protocol) terminal is used
to connect the VCR to a personal computer or similar
device. By connecting through the JLIP terminals, you
can control the VCR during editing and certain other
operations, from the connected personal computer or
similar device.
When connecting this VCR to another device using the
JLIP terminals, each device must have a different JLIP ID
number.
The JLIP ID number of this VCR is preset to “1” when
shipped from the factory. You can change this number to
any other number between 1 to 99.
To change the JLIP ID number of this VCR, follow the
procedure below.
1
Access Main Menu screen
Press MENU.
2
Access Initial Set screen
On the front panel:
Press CH5∞ to move
the highlight bar (arrow)
to “INITIAL SET”, then
press OK.
On the Remote:
Press %fi to move the
highlight bar (arrow) to “INITIAL SET”, then press
OK or
#
.
3
Select JLIP ID Number Set screen
On the front panel:
Press CH 5∞ to move
the highlight bar (arrow)
to “JLIP ID NO. SET”,
then press OK.
On the Remote:
Press %fi to move the
highlight bar (arrow) to
“JLIP ID NO. SET”, then press OK or
#
.
4
Set JLIP ID Number
On the Remote ONLY:
Press the Number keys
to enter the desired ID
number, then press OK.
5
Return to normal screen
Press MENU.
NOTE:
For further details on the JLIP system or devices, consult your
nearest JVC dealer.
U.S. customers can contact JVC directly toll free at 1-800-252-
5722.
MAIN MENU
FUNCTION SET
TUNER SET
=
INITIAL SET
REC LEVEL CTL
VIDEO NAVIGATION
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END
INITIAL SET
CLOCK SET
LANGUAGE ENGLISH
GUIDE CHANNEL SET
CABLE BOX SET
DBS RECEIVER SET
=
JLIP ID NO. SET
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
JLIP ID NO. SET
1
PRESS NUMBER KEY (O-9)
THEN (OK)
PRESS (MENU) TO END
1 5
2 3
2 3
123
456
7
89
0
VCR TV CABLE/DBS
1 5
2 3
2 – 4
2 3
4
HR-S9800U-EN56-63 00.3.29, 7:29 PM63